Two-handed casting rod in principle no different from the one-handed casting rod. However, in this case is not possible to lengthen the cord with his left hand while performing blank casting, as it should be on the butt rod below coil. We fix the cord, holding his finger to the handle rod, ring and middle fingers of his right hand. The left thumb is on the handle of the rod and sent it along, the index finger clip handle rod. Free cable slack loop in the area between the coil and the right hand. Releasing it from the fingers of his hands already in the rectification column at the time of stroke forward, or rather, a little earlier.
The successful flight of the cord can be feel even through the rod. Thus, 'shoots' cord just like the one-handed rod. Executing a throw, give sights to fall into the water, harvested area and casting, if not biting his left hand pulling the coil additional loop. Put your left hand on the handle of the rod below the reel, the cord pulls the handle with his right hand, lower right hand – the cord loop sagging. This is followed by swing back – pause, forward stroke – a pause as he ran down sagging power cord out from under his fingers, and finally catching beauty spot radius is extended by the length of the free loop. Naturally, the two-handed casting rods rhythm is slower than the one-handed, and the angle of the butt grip is very small. Many enjoy the reception, at which the left arm during a throw almost stationary, and serves as a support. When fishing with sinking rope, especially if the cord and bead had go deep, it should be before the stroke back his left hand out of the water a few meters cord.